Rechargeable Scooter LED Light – Remote-Controlled

Customise your scooter lighting with a rechargeable LED light featuring remote control, selectable colours and adjustable brightness. Check mounting suitability and the contents of your selected option before ordering.

Listed features

• USB Type-C charging
• Approximately 60-minute charging time
• Remote range: approximately 7 metres
• 10 light modes
• High, medium and low brightness settings
• Three custom-mode memory buttons

Light modes and colours

Modes: Pilot Flash, Pop Flash, Aircraft Flash, a cycle of modes 1–3, SOS (slow/fast flash), Breathing, Slow Flash, Strobe, Warning Flash and Steady On.

Colours: White, Red, Green, Blue, Yellow, Purple, Pink and Ice Blue. AUTO cycles through all eight colours.

Modes 1–5 offer a single flash colour or colour cycling. Modes 6–9 offer dual-colour flashing or colour cycling. To select two colours, press the first colour button, then the second. Press the same colour button twice to use one colour for both flashes.

First-time pairing

1. Remove the transparent protective film from the back of the remote.
2. Following the supplier instructions, remove the dust plug, connect the remote to a charger for five seconds, then unplug it. The light should turn on automatically.
3. Press a colour button within three minutes of power-on. A colour change confirms pairing.
4. Repeat for each additional light. One remote can control several lights. Press Steady On and V together to synchronise their modes and colours.

The supplier describes a faint green charging indicator that becomes brighter when fully charged. Follow the supplied instructions for your unit.

Remote controls

• Power: long press to switch on or off.
• Brightness: cycle through high, medium and low. Lower brightness extends battery life.
• Mode + / –: move through the light modes.
• Steady On: select constant lighting at medium brightness, then adjust brightness if needed.
• Custom Mode 1 / 2 / 3: long press to save the current colour, brightness and pattern; short press to recall it.

Important notes

• The remote sleeps after more than 60 seconds of inactivity. Long press any button to wake it.
• The remote cannot be used while charging.
• Do not stare directly into the light.
• Clean the mounting surface before applying Velcro tape.
• Follow the supplied mounting and charging instructions. The supplier warns against improper use.

This is an accessory light, not a guarantee of collision prevention or a replacement for required vehicle lighting. Before using flashing or coloured modes on public roads, check the applicable rules for your location.